KopTalk.com Forums Petrol 'eds thread!

Might work differently on your side,but here you need to have a basic pack(bbc and other sh1te) and then you can pick a premium pack(sports,movies,e.t.c)

Scandalous.

Disc pads should be mega simple on the Tranny Wakio tbh.
They're all much of a mucness to do.

First, you need to jack the van up and find the wheel brace and take the wheel off, remembering to secure the vehicle into axle stands (SERIOUSLY).

Remove clips or whatevers holding pads in, and drag old pads out with long nosed pliers.
Squeeze calipers in as dar as they can go using something like a block of wood, but nowt sharp that could damage them. Slide new pads in, secure, and voila!

Check out the intermong for more detailed job description, problee with piccies too.

Just came across a Haynes manual,sorted now,I have done a couple of cars before,looks the same.

Axle stands,that made me laugh.

Why?

Essential if you're heaving banging and pulling under a vehicle, and even werse if you're actually doing some werk on it!

I will throw a block under the wishbone,good enough.

Well if we never see you posting in here again, we know why.
Just be careful matey. You don't gerra second chance if it does slip or the jack fails, and NO, I'm NOT an H&S geek either, just CS...common sense.

Oh, and don't forget to wear a HV jacket too!

I wont be under it so even if she does go,it will only be a busted hub or so,now where the hell is me Torque Ratchet?

Well he aint back yet.

He's of his trolley...hopefully not with it on top of him.
You haven't actually got to be under the vehicle for it to suddenly drop. Fettlin' about, tugging away at the pads and calipers could be sufficient for it to fall.
Just to have your mitt in the wrong place would be catastrophic if it fell.

Come on Wak. Tell us you've sorted it.

Sorry to disapoint you sadomasichists but I am well and truly still here,no falling vans or nothing,simple job,one little problem where some gobshite had broken a torx bit in the caliper pin and I had to get the Vise Grip on it,only took about 1 1/2 hours in total.